Difference between revisions of "UFR 4-18 References"

From KBwiki
Jump to navigation Jump to search
Line 21: Line 21:
 
* L. A. Dvorak (2004). Turbulent Augmentation of Heat Transfer off Pin and Endwall Surfaces in a Staggered Pin Fin Array. Master of Science Thesis, the University of North Dakota, December, 2004.
 
* L. A. Dvorak (2004). Turbulent Augmentation of Heat Transfer off Pin and Endwall Surfaces in a Staggered Pin Fin Array. Master of Science Thesis, the University of North Dakota, December, 2004.
  
* Moffat, R.J., 1988, “Describing Uncertainties in Experimental ResultsExperimental and Fluid Science, 1, pp 3-17.  
+
* R. J. Moffat (1988). Describing Uncertainties in Experimental Results. Experimental and Fluid Science, 1, pp 3-17.  
  
 
* C. A. Nordquist (2006). Pin Fin End Wall Heat Transfer Distributioin with an Adiabatic Pin Acquired using an Infrared Camera. Master of Science Thesis, the University of North Dakota, June, 2006.  
 
* C. A. Nordquist (2006). Pin Fin End Wall Heat Transfer Distributioin with an Adiabatic Pin Acquired using an Infrared Camera. Master of Science Thesis, the University of North Dakota, June, 2006.  

Revision as of 15:41, 12 April 2014

Flow and heat transfer in a pin-fin array

Front Page

Description

Test Case Studies

Evaluation

Best Practice Advice

References

Confined Flows

Underlying Flow Regime 4-18

References

List references describing in detail the relevant measurements, turbulence models, numerical methods, CFD results etc.


  • F.E. Ames and L. A. Dvorak (2006). Turbulent Transport in Pin-Fin Arrays: Experimental Data and Predictions. ASME J. of Turbomachinery, Vol. 128, pp. 71-81.
  • F.E. Ames and L. A. Dvorak (2006). The Influence of Reynolds Number and row Position on Surface Pressure Distributiions in Staggered Pin Fin Arrays. Proc. GT2006 ASME Turbo Expo 2006: Power for Land, Sea and Air, May 8-11, Barcelona, Spain.
  • F. E. Ames, L. A. Dvorak and L. J. Morrow (2005). Turbulent Augmentation of Internal Convection Over Pins in Staggered Pin-Fin Arrays. ASME J. of Turbomachinery, Vol. 127, pp. 183-190.
  • F. E. Ames, C. A. Nordquist and L. A. Klennert (2007). Endwall heat transfer measurements in a staggered pin-fin array with an adiabatic pin. Proc. GT2007 ASME Turbo Expo 2007: Power for Land, Sea and Air, May 14-17, Montreal, Canada
  • L. A. Dvorak (2004). Turbulent Augmentation of Heat Transfer off Pin and Endwall Surfaces in a Staggered Pin Fin Array. Master of Science Thesis, the University of North Dakota, December, 2004.
  • R. J. Moffat (1988). Describing Uncertainties in Experimental Results. Experimental and Fluid Science, 1, pp 3-17.
  • C. A. Nordquist (2006). Pin Fin End Wall Heat Transfer Distributioin with an Adiabatic Pin Acquired using an Infrared Camera. Master of Science Thesis, the University of North Dakota, June, 2006.





Contributed by: Sofiane Benhamadouche — EDF

Front Page

Description

Test Case Studies

Evaluation

Best Practice Advice

References



© copyright ERCOFTAC 2021